Добрый день!
Купили 2 преобразователя 2150 для соединения и получения двух СОМ портов через WiFi.
Проблема такая что при подаче питания на два модуля они не соединяются друг с другом, но стоит снять питание
с одного из модулей и подать его снова то они тогда соединяются и работают без проблем, собственно вопрос что делаю не так.
И есть ли документация на этот модуль на русском, хотя в принцыпе всё понятно но хотелось бы.
1 модуль:
Ethernet Settings:
IP Configuration - Static
IP Adress - 10.1.24.192
Net Mask - 255.255.255.0
Gateway - пусто
Speed - Auto
WLAN:
IP Configuration - Static
IP Adress - 10.1.24.190
Net Mask - 255.255.255.0
Gateway - пусто
Profile:
Network Type - Ad-hos Mode
Profile name - Ad-hos
Advanced Settings:
Gratuitous ARP - dasbled, send period 300
Serial Port Settings:
Application - Pair Connection
Mode - Pair Connection Slave
TCP alive check time - 1
TCP port - 4002
Setting port:
Baud rate - 9600
Parity - None
Data bits - 8
Stop bits - 1
Flow control - None
FIFO - Enabled
Interface - RS232
2 модуль:
Ethernet Settings:
IP Configuration - Static
IP Adress - 10.1.24.193
Net Mask - 255.255.255.0
Gateway - пусто
Speed - Auto
WLAN:
IP Configuration - Static
IP Adress - 10.1.24.191
Net Mask - 255.255.255.0
Gateway - пусто
Profile:
Network Type - Ad-hos Mode
Profile name - Ad-hos
Advanced Settings:
Gratuitous ARP - dasbled, send period 300
Serial Port Settings:
Application - Pair Connection
Mode - Pair Connection Master
TCP alive check time - 0
Destination address - 10.1.24.190 Port - 4002
Setting port:
Baud rate - 9600
Parity - None
Data bits - 8
Stop bits - 1
Flow control - None
FIFO - Enabled
Interface - RS232